| | Coverage: 9-13 Sqft. (Standard Spacing) 7-9 Sqft. (Alternate Spacing) | Length & Resistance: Cable Length: 42 Linear Feet Resistance Range: 103.74 - 120.12 Ω | Electrical Requirements: 120 Volts 1.1 Amps | All Cable Kits include: A Warm Tiles® Floor Warming Cable, Floor Strapping, Floor Clips, Installation Instructions, User's Guide, and Warranty Information. Thermostat Kits, Extra Temperature Sensor and Detecto Monitor sold separately. | Description:Even in warm climates, tile and stone can feel uncomfortably cold. Warm Tiles® offers the ultimate solution by removing the chill factor with a gentle, continuous warmth. Warm Tiles Electric Floor Warming Systems may be installed directly over plywood, concrete or cement backerboard substrates. The floor warming is placed in the mortar below the tiles, simplifying the installation.The Warm Tiles Cable system provides unlimited design configurations for even the most difficult shaped room. The Warm Tiles cable allows you to install full floor warming coverage by lacing the cable on the floor wherever you require a heated area.Two different spacing options enable these extremely flexible cables to be installed virtually anywhere. In a typical room above a heated area, simply space the cable 3”(7.61 cm) apart. For a room above an unheated area, on concrete slabs or a high heat loss room such as a solarium, alternate the spacing from 3”(7.61 cm) apart, then 1.5”(3.80 cm) apart, then 3”(7.61 cm) apart and so on. Simply snap the cable into the strapping included in your Cable Installation Kit and follow the Cable installation instructions.You must use a Warm Tiles Relay Kit when connecting two or more floor warming kits that have a combined total load amperage exceeding 16 amps. Heating cables CANNOT BE CUT and must be embedded completely in mortar beneath the floor finish. |
|
|